Komatsu — 24.8.9 CHECK TORQUE OF SPROCKET MOUNTING BOLTS

24.8.7 CLEAN NEUTRAL VALVE INLET STRAINER Remove the operators seat and seat mounting plate. Remove the hose coming from the pressure regulator valve to the neutral valve inlet strainer. Remove the strainer assembly from the neutral valve. Remove the strainer body (1) from the connector and strainer element (2). Using a commercial solvent, wash the element and housing and dry thoroughly. Replace the o-rings (3 and 4). REMARK The strainer element is soldered to the connector. If the strainer shows any sign of deterioration or remains plugged after cleaning, replace it. 3. Remove all dirt from the neutral valve. Reinstall the strainer and connect hose.

Start the engine and let it idle for 5 minutes. During this time check the strainer for leaks and correct, no matter how minor. 4. Install seat plate and seat. Check the drive train system oil level. For details of the fluid to use, see 20 USE OF FUEL, COOLANT AND LUBRICANT ACCORDING TO AMBIENT TEMPERATURE on page 3-8. 24.8.8 LUBRICATE VALVE CAM PLATE 1. Remove control knob and control cover boot. Clean the cam surface and apply a generous amount of MPG to the cam. 2. Inspect control cover boot for tears or any sign of deterioration. Replace if any are found. 3. Wipe off all dirt/dust from the boot mounting surface and install control cover boot with hardware removed. Install control knob.

24.8.9 CHECK TORQUE OF SPROCKET MOUNTING BOLTS Check torque of sprocket mounting bolts. Torque D32E-1 D38E-1 Early Version 3/4NF - 455 Nom (335 Ibf ft) D32E-1 D38E-1 Later Version 3/4NC - 455 N-m (335 Ibf ft) I 8 I I D32P-1 D38P-1 1 3/4NC-455 Nom (335 Ibfft) 1 8 1 I D39E-1 D39P-1 I 3/4NC -455 Nom (335 Ibfft) I 12 I 3-47