Komatsu — 24.9.1 DRAIN, FLUSH AND REFILL COOLING SYSTEM

MAINTENANCE 24.9 EVERY 2000 HOURS SERVICE 24.9.1 DRAIN, FLUSH AND REFILL COOLING SYSTEM a WARNING Soon after the engine has been stopped, the coolant is hot and can cause personal injury. Allow the engine cool before draining the coolant. Never remove the radiator cap when the engine is at operating temperature. At operating temperature, the coolant is under pressure. Steam blowing up from the radiator could cause personal injury. Allow the engine to cool until the radiator filler cap is cool enough to touch with your hands. Remove the filler cap slowly to relieve pressure. Never be under the machine with the engine running.

To avoid serious injury, always stop the engine before being under the machine to open the drain valve. When removing drain plug, avoid pouring coolant on yourself. Antifreeze is flammable, so keep it away from any flame. Flushing agents, neutralizing agents, and anticorrosive agents are strong acids or alkalize, so be careful not to get them on your skin. If you should get any of these on your skin, wash off immediately with ample water. After using the agent, do not use the empty packet for keeping food, etc. Draining the System 2. Remove the crankcase coolant drain plug located on the bottom of the coolant inlet. 1. Turn the radiator cap slowly to remove it. 3.

Open the radiator drain valve. Allow the system to completely drain into a suitable container. Do not let drain outlets plug up during draining. 4. Close the radiator drain valve. Install the crankcase drain plug. Flushing the System 1. Be sure the radiator drain valve and crankcase drain plug are closed and tightened. 2. Fill the system with clean water and add a flushing compound that is compatible with aluminum. Flush the system in accor- dance with the instructions furnished with compound. 3. After flushing, rinsing and completely draining the system, refill with clean coolant, see the following. Refilling the System 1.

Be sure the radiator drain valve and crankcase drain plug are closed and tightened. 2. Fill the cooling system to maximum capacity. Fill with antifreeze according to the instructions printed on the container. + For details of the fluid to use, see 20 USE OF FUEL, COOL- ANT AND LUBRICANT ACCORDING TO AMBIENT TEMPER- ATURE on page 3-8. 3. Start engine and run until normal operating temperature is reached. Add coolant to keep the proper level at the bottom of the filler neck tube. After all air is removed and level remains fixed, install the radiator cap. 3-48