Komatsu — 24.9.4 CHANGE HYDRAULIC SYSTEM FLUID

2. Slowly loosen the filler plug on the reservoir in order to relieve any pressure in the reservoir, then retighten. 3. Remove the lock ring (1) and cover (2). Remove the element (3) and clean in a nonflammable commercial solvent. Dry thoroughly. Check o-ring (4) for wear or deterioration. Replace if necessary. Replace filter (3) and cover (2). Secure with lock ring (1). Reinstall the filler cap. 24.9.4 CHANGE HYDRAULIC SYSTEM FLUID 1. Start the engine and operate the blade to warm the oil for easy draining. 2. Position the machine to permit the blade to drop below ground level.

Be sure the piston rods are completely extended so the blade is entirely supported by both cylinders at the maximum LOWER position. Place the control lever in the FLOAT position. 3. Stop the engine. Shift to neutral and apply the neutral lock lever. Apply and lock the parking brake. Turn the electrical system master switch to OFF. Slowly loosen reservoir filler plug to relieve reservoir pressure. 4. Drain the reservoir into a suitable container by removing the filler plug and the drain plug. 5. Service the return filter and the suction strainer. REMARK Use clean oil from a clean container. Maintain all packaging and fittings so as to prevent leakage. 6. Reinstall the drain plug.

Fill the reservoir with lubricant up to the center line of the sight gauge. Reinstall the filler cap. + For details of the fluid to use, see 20 USE OF FUEL, COOL- ANT AND LUBRICANT ACCORDING TO AMBIENT TEMPER- ATURE on page 3-8. 7. Start the engine and run it at low idle speed. Operate all the controls through all positions four or five times so the cylinders are filled with oil and air expelled. Check the oil level and repeat until the fluid level remains at the specified level in the reser- voir. 3-50