Komatsu — 24.10.1 CLEAN AIR CLEANER ELEMENTS

24.10 PERIODIC 24.10.1 CLEAN AIR CLEANER ELEMENTS General This machine is equipped with a dry-type air cleaner with replace- able filter elements. The air cleaner has two elements, a primary and a safety. The primary element can be cleaned for a limited number of times before replacement is necessary, however, the safety element must be replaced when plugged. Detailed service procedures for this air cleaner are covered in the following text. Precautions As a precaution against dirt entering the engine: + Make sure the air cleaner connections and the turbocharger mounting gaskets are in good condition and all joints and connections are tight.

+ Never operate the engine unless a filter element is in place and the filter end cover gasket is installed. + Never remove the element from the air cleaner while the engine is running. Primary Filter Element SERVICE The air cleaner primary element must be serviced whenever indicated by the air cleaner filter service light, See 11.2 GAUGES AND WARNING LIGHTS on page 2-5. After servicing the primary element, if the air cleaner filter service light continues to operate, check the air inlet screen or precleaner tubes for obstructions. If service remains illuminated, replace the safety element.

After servicing the primary element and replacing the safety element, if the service light continues to operate, replace the primary element too. 1. Primary Filter Element 2. Safety Filter Element 3. Dust Vacuator Valve The primary element can be cleaned by either of two methods: washing or compressed air. Washing is the preferred method as it removes more dust and soot and restores the element to an almost new condition. The result is better performance and longer intervals between required element service. It is suggested that a spare element be obtained for use while the serviced element is drying. REMARK A filter element must be replaced after six washings or clean- ings.

Cleaning the element with compressed air is not an entirely satisfactory method. Some dust will remain in the element causing more frequent servicing of the element. Use this method only as a temporary measure until time is available to wash the element. REMARK After cleaning, if an element is to be stored for later use, place it in a plastic bag and store in an element shipping container to protect against dirt and damage. 3-51