Komatsu — 24.10.1 CLEAN AIR CLEANER ELEMENTS

MAINTENANCE REMOVAL 1. Stop the engine and lower all mounted equipment to the ground. Open the right engine side door. Remove all dirt from the cover end of the air cleaner body. 2. Loosen the wing nut (1) on the cover (2) and remove the cover from the air cleaner body. 3. Remove the wing nut with gasket (3) and slide out the primary element (4) being careful not to dislodge dust from the dirty element onto the safety element. 4. Check the condition of the gasket on the end of the primary element. If the gasket is damaged or missing, replace the element. Remove all dirt from the inside of the air cleaner body with a damp cloth.

A small amount of nonsudsing detergent WASHING REMARK Never wash elements in fuel oil, gas or solvent. DO NOT OIL ELEMENTS. Do not attempt to take elements apart. Do not tap the element against a hard surface; this will damage the element. 1. Carefully tap the side or end of the element against the palm of your hand to remove loose dirt. 2. Wash the element in clean, warm water, 21 to 38°C (70 to 100°F). A small amount of nonsudsing detergent added to the water will remove the soot. 3-52