MAINTENANCE 3. Rinse the element in clear water (if a hose is used, do not exceed 275 kPa (40 psi). Shake the element carefully to remove excess water. REMARK Do not use compressed air to speed the drying of the element; the air pressure will rupture the wet element. 4. Lay the element on its side and allow it to air dry before reinstalling. Overnight drying is usually sufficient. When drying the element, protect it from dirt and/or freezing. REMARK If no spare element is available, the wet element, after excess water has been shaken out, may be installed in the air cleaner and the engine operated at low idle for 10 minutes before operating the machine. 5. Inspect the element for damage.
COMPRESSED AIR A WARNING Wear eye protection when using air under pressure to clean parts. Limit air pressure to 206 kPa (30 psi). REMARK Do not tap the element against a hard surface; this will damage the element. 1. Carefully tap the side or end of the element against the palm of your hand to remove loose dust. 2. Direct clean dry compressed air up and down the pleats on the inside of the element. Always direct the flow of compressed opposite the normal operating air flow direction through the element. 3. Inspect the element for damage. INSPECTION 1. Inspect the filter element for leaks or damage by placing a bright light inside the element.
Inspection of the element on the outside will disclose any holes where concentrated light shines through. The slightest rupture requires replacement of the filter element. 2. Inspect the contact surfaces of the air cleaner body. If faulty or damaged surfaces are noted, correct these conditions immedi- ately. 3-53