Komatsu — 24.11.2 ELECTRICAL SYSTEM

MAINTENANCE 24.11 WHEN REQUIRED 24.11 .l FAN BELT Checking Tension The engine is equipped with an automatic belt tensioner that maintains correct tension on the drive belt. To check belt tension a Burroughs type gauge must be used because of the wide drive belt. Proper tension should be 110 to 150 N (80 to 110 Ibs). If a Burroughs type gauge is not available, tension may be checked by belt deflection. Press the belt with your finger at the longest span and measure the deflection. Maximum deflection 9.5 to 12.7 mm (0.37 to 0.50 in). Adjusting With the automatic tensioner, adjustment isn’t required. Replacement To replace the drive belt, remove the left finger guard. Then place a ‘/2 in.

drive breaker bar (1) in the square hole in the belt tensioner. Push the breaker bar UP to loosen the tensioner. Remove the old belt (2). Inspect belt tensioner. The tensioner pulley should spin freely with no rough spots detected under hand pressure. Install the new belt. 24.11.2 ELECTRICAL SYSTEM Precautions A WARNING Before working on the engine or electrical system, disconnect the negative (ground) battery cable. Tag the cable and controls to warn against starting. When installing the battery be sure to connect the ground cable to the negative terminal.

When connecting a booster battery or battery charger make certain to connect the negative terminal to the negative terminal and the positive terminal to the positive terminal. Do not short across or ground any terminals of the alternator or regulator. Failure to observe these precautions will result in severe damage to the harness and alternator. All terminals must be clean and fastened securely. Never paint electrical connections or the alternator. Repair or replace all broken wires immediately. Surface under all terminals must be clean and good electrical connections must be established after reassembly. Also all clips must grip cables tightly to prevent vibrations and rapid cable wear.

All clips and straps must be closed in a workmanlike manner, so as not to damage the insulation. 3-58