Battery GENERAL a WARNING A battery gives off highly flammable gas. Never allow sparks, open flame or lighted smoking material near the battery. Avoid spilling any electrolyte on hands or clothing. Always wear safety glasses when working on a battery. When using a booster battery and jumper cables, connect the negative (ground) cable to the machine’s frame, away from the battery. Always connect the ground cable last and disconnect it first to avoid sparks near the battery. A spark could cause a battery explosion and injury. Never check the battery charge by placing a metal object across the terminals. The sparks could cause a battery explosion.
Use a voltmeter or hydrometer to measure charge. Be sure the electrical system master switch is off when connecting or disconnecting the battery to minimize the chance of sparks and explosion. The machine is equipped with one 12 volt battery. It is located in the battery box. Never allow a battery to stand on concrete, ground or a metal support unless proper insulation is provided. A wooden platform or board is sufficient insulation. Be sure the battery is fastened securely to avoid damage from vibration. MAINTENANCE Proper battery maintenance will assure maximum service. Follow- ing are a few simple rules: + Keep battery cable terminals clean and tight.
+ Keep filler cap vent holes unplugged. + Replace worn, cracked, broken or corroded cables. + Keep battery fastened securely in frame. REMARK Excessive tightening can warp or crack battery case. + Maintain the correct battery liquid level. (Conventional battery only). + Always charge the battery in a ventilated area. + Keep the battery clean. 3-61