MAINTENANCE Circuit Breakers The lighting and horn circuits are protected by an automatic reset circuit breaker (1). A 20 amp circuit breaker is mounted on the underside of the instrument panel. In the event of a short circuit or ground, the circuit breaker will open and close until the trouble clears or is corrected. The circuit breaker will then return to and stay in its normal closed position. It is important to use the same capacity circuit breaker for replacement. To install a new circuit breaker, remove the instrument panel and pull from housing. Retain nuts and remove the two screws (panel face) securing the circuit breaker.
Disconnect the wiring and replace with a new circuit breaker. The starting and ether circuits are protected by an automatic reset circuit breaker (2). A 20 amp circuit breaker is mounted on the underside of the instrument panel. In the event of a short circuit or ground, the circuit breaker will open and close until the trouble clears or is corrected. The circuit breaker will then return to and stay in its normal closed position. It is important to use the same capacity circuit breaker for replacement. To install a new circuit breaker, remove the instrument panel and pull from housing. Retain nuts and remove the two screws (panel face) securing the circuit breaker.
Disconnect the wiring and replace with a new circuit breaker. The back up alarm, fuel gauge, gear range indicator, gauge cluster lamps, and engine shut down solenoid circuits are protected by an automatic reset circuit breaker (3). A 6 amp circuit breaker is mounted on the underside of the instrument panel. In the event of a short circuit or ground, the circuit breaker will open and close until the trouble clears or is corrected. The circuit breaker will then return to and stay in its normal closed position. It is important to use the same capacity circuit breaker for replacement. To install a new circuit breaker, remove the instrument panel and pull from housing.
Retain nuts and remove the two screws (panel face) securing the circuit breaker. Disconnect the wiring and replace with a new circuit breaker. REMARK Under the inside mounting screw nut on the 6 amp circuit breaker there are a pair of two ground wire connectors. 3-60