CHARGING FULLY DISCHARGED MAINTENANCE-FREE BATTERY When a machine is not in use for an extended period, the maintenance-free battery can become discharged. For this reason, when a machine will not be used for over 30 days, it is recom- mended that the negative ground terminal cable be disconnected. Prior to starting up a machine that has been idle, always make a visual inspection of the battery and take an open circuit voltage test. A reading of 12.3 volts (65% of full charge) or less indicates a state of discharge. The open circuit voltage test should be taken after removing the surface charge. This is accomplished with a draw of 300 amps for 15 seconds.
Wait for a couple of minutes, then check the open circuit voltage. The point to remember is the lower the open circuit voltage, the longer it will take before the battery begins to accept a measurable amount of charge. Charge the battery until a minimum open circuit voltage of 12.4 volts is reached. Then test the battery. If an open circuit voltage reading of 12.4 volts is not attained at the end of 12 hours, it can be assumed that the battery has failed. If the voltage does not drop below 9.6 volts at 21 “C (70°F) for the duration of the load test, the battery is good. 24.11.3 ETHER START Precautions a WARNING Ether starting fluid is highly flammable.
Follow the precautions on the container. An explosion can result if sparks or flame contact the ether or if the container is stored where the temperature exceeds 49°C (120°F). Observe the following precautions: Do not use the ether injector when the air temperature is above freezing. Do not smoke when using ether starting fluid. Do not store fluid containers in the operator’s compartment. Store the containers in a cool, well-ventilated place. Keep the fluid containers out of the reach of children. Do not breathe the hazardous ether vapor. Do not let ether contact you skin, because it can cause frostbite. Never puncture the fluid container or put it into a fire.
Dispose of empty containers properly. For your safety, remove the ether container when welding, grinding, or using a torch on the machine. Follow the correct method for starting the engine, See 12.2.2 COLD WEATHER STARTING on page 2-32. REMARK Improper starting fluids can cause valve seizure and severe damage to the engine. Consult your distributor for the recom- mended starting fluid to be used. REMARK The ether starting valve inlet must be sealed against the entry of dirt at all times by having a fluid container installed or by installing the dust cap provided with the valve. 3-63