Komatsu — 24.11.3 ETHER START

IN STORAGE aerwce Make certain that ether is available under pressure. To do so, remove the ether container and check if a good spray is obtained. If not, replace with a new container. If a good spray was obtained, reinstall the container and test the ether injector as follows: Disconnect the ether tube at the spray nozzle in the engine manifold. Remove the spray nozzle. Reconnect the nozzle to the tube. Direct the nozzle away from the engine and actuate the ether injector. Dribbling or no spray indicates a blocked spray nozzle or tube. If necessary, clean or replace spray nozzle and/or tube. 1. Unscrew the plastic fluid container housing from the ether starting valve.

Remove fluid container and check condition of o-ring. Discard the empty fluid can in a suitable, closed refuse container. 2. Install the new fluid container in the plastic housing. Secure the container in place by threading it into the valve. 3-64