24.11.4 VENTING THE FUEL SYSTEM Controlled venting is provided at the injection pump through the fuel drain manifold. Small amounts of air introduced by changing the filter or injection pump supply line will be vented automatically, if the fuel filter is changed in accordance with the instructions. Manual bleeding is required if, the fuel filter is not filled prior to installation, initial engine start up or start up after an extended period of on engine operation or the machine fuel tank has run empty. Low Pressure Filter Lines and Fuel Filter 1. Open the vent screw (1). Operate the pump lever (2) on the fuel lift pump until the fuel flowing from the fitting is free of air.
Tighten the vent screw. High Pressure Lines The pressure of the fuel in the line is sufficient to penetrate the skin and cause serious bodily harm. + For your personal protection never perform any adjust- ments alone with the engine running. Always have another experienced person helping in the operator’s compartment when adjustments must be done with the engine running. When making adjustments, lock the safety lever in the down position and apply the brake. a WARNING Venting is accomplished by loosening one injector fitting and cranking the engine to allow entrapped air to bleed from the line. 1.
Loosen the fitting at the injector, and crank the engine to allow entrapped air to bleed from the lines. Tighten the fittings. 2. Start the engine and vent one line at a time until the engine runs smoothly. REMARK Run engine at low idle when venting lines. 24.11.5 ANGLING FRAME TO BLADE Periodically or as required the lower (1) and upper (2) shims (both sides) may have to be removed to take up wear between the angling frame (3) and the blade (4). The gap between the angling frame and blade should not exceed 3 mm (0.12 in) minimum gap. The lower shim pack is to consist of no less than 1 shim and no more than 6 shims.
The upper shim pack is to consist of no less than 2 shim and no more than 7 shims. The gap should permit free movement between the angling frame and blade without any binding. 3-65