0 x 2 3 c --------- @@@@, + --_------ 1 l - 24.11.6 REVERSE AND REPLACE THE END BITS AND CUT- TING EDGES A WARNING It is dangerous if the work equipment moves by mistake when the cutting edges and end bits are being reversed or replaced. Set the work equipment in a stable condition, then stop the engine and lock the blade control lever securely with the safety Reverse or replace the cutting edges before it is worn out to the blade end. 1. Raise the blade to a proper height and apply a block to the frame so as to prevent fall of the blade. 2. Measure the wear of the cutting edge in accordance with the wear standards given below. Unit: mm (in) Item I Judgement standard No.
Measurement point Standard dimension Repair limit D32E&P 76.2 (3.0) 1. Height of cutting edge (from center D38E&P of bolt mounting hole to end face) D39E&P 101.6 (4.0) 58 (2.3) If the cutting edge on both sides is worn out, replace with new one. If it has been worn out up to the fitting surface, repair the fitting surface and then reverse or replace. 3. Remove the cutting edge and clean the mounting surface. 4. Reverse or replace the cutting edge when worn out. u Nut tightening torque . . . . . . . . . . 455 Nern (335 Ibf ft) If bolt 0 and nut 0 are damaged, replace them with new hardware at the same time. 3-66