Komatsu — 24.12.5 COOLING SYSTEM

MAINTENANCE 24.12 SEASONAL PREPARATION 24.12.1 GENERAL Proper maintenance and mechanical efficiency is enhanced during seasonal air temperatures changes, when the following instructions are followed. 24.12.2 OUTSIDE SOURCE OF HEAT Machines left outside for prolonged periods in sub-zero weather will suffer from cold-soak. Lubricants become viscous and incapable of lubricating moving parts. Extreme wear could result to the engine, transmission and final drives unless proper precautions are taken. A source of outside heat is necessary under these conditions. There are electric as well as propane-fired engine coolant heaters available.

Gas-fired forced air heaters may also be obtained to heat the transmission and final drives. When using such, be sure to follow the manufacturer’s instructions for personal safety. A WARNING Use caution and follow the manufacturer’s instructions when using external heaters to warm the power train in cold weather. 24.12.3 LUBRICATION Lubricate and service your machine at intervals specified, see 23 MAINTENANCE SCHEDULE CHART on page 3-23. Service performed at specified intervals will prolong the life of the machine, See 20 USE OF FUEL, COOLANT AND LUBRICANT ACCORD- ING TO AMBIENT TEMPERATURE on page 3-8.

Always select oils and lubricants specified at Anticipated Air Temperature when making seasonal preparations. 24.12.4 FUEL SYSTEM For details of the fuel to use, see 20 USE OF FUEL, COOLANT AND LUBRICANT ACCORDING TO AMBIENT TEMPERATURE on page 3-8. 24.12.5 COOLING SYSTEM Prepare the cooling system as follows: 1. Check the entire system for leaks. 2. Inspect the condition of all hoses and replace the hoses and hose clamps as necessary. 3. Check the operation of the thermostat by observing the engine coolant temperature gauge on the instrument panel during operation. If the engine warms up slowly, the thermostat may be stuck in the open position.

If the engine overheats, the thermostat may be inoperative by remaining closed. 3-71