MAINTENANCE REMARK If improper thermostat operation is indicated, refer to your Engine Shop Manual for removal and installation procedures. Clean cooling system and add coolant conditioner. For this procedure, see 24.9.1 DRAIN, FLUSH AND REFILL COOLING SYSTEM on page 3-48. Check the tension and condition of the belts and adjust or replace if necessary. For these procedures, See 24.11 .l FAN BELT on page 3-58. Remove all debris from the radiator core using air or water under pressure.
Direct the flow through the core, opposite the normal direction of air flow A WARNING For your personal protection, water pressure should not exceed 275 kPa (40 psi) and air pressure should not exceed 210 kPa (30 psi). Wear eye protection. Clean the radiator guard and outside of the core. Protect your cooling system from damage by using an anti- freeze coolant. See 20.2 COOLING SYSTEM on page 3-l 1. Keep your cooling system clean and minimize corrosion by adding coolant conditioner at correct intervals. See 20.2 COOLING SYSTEM on page 3-l 1. 24.12.6 ELECTRICAL SYSTEM Remove all corrosion from battery terminals and cables.
Repair or replace all wires which have worn, cracked or frayed insulation and broken or loose wires. Service the battery. See 18.2 ELECTRICAL SYSTEM on page 3-6. 3-72