Komatsu — 16.2.1 STARTING ENGINE WITH BOOSTER CABLE

OPERATION 16. TROUBLESHOOTING 16.1 AFTER RUNNING OUT OF FUEL When starting after running out of fuel, fill with fuel, then fill the fuel filter cartridge with clean fuel and bleed the air from the fuel system before starting. For details of bleeding the air, See 24.11.4 VENT- ING THE FUEL SYSTEM on page 3-65. 16.2 IF BATTERY IS DISCHARGED A WARNING When checking or handling the battery, stop the engine and turn the starting key to the OFF position before starting. The battery generates hydrogen gas, so there is danger of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause sparks.

Battery electrolyte is dilute sulphuric acid, and it will attack your clothes and skin. If it gets on your clothes or on your skin, wash it immediately off with large amounts of water. If it gets in your eyes, wash it out with fresh water, and consult a doctor. When handling battery, always wear protective goggles. When removing the battery, first disconnect the cable from the ground (normally, from the negative (-) terminal). When installing, install the positive (+) terminal first. If a tool touches the cable connecting the positive terminal and the chassis, there is danger that it will cause sparks.

If the terminals are loose, there is danger that the defective contact may generate sparks that will cause an explosion. When installing the terminals, install them tightly. 16.2.1 STARTING ENGINE WITH BOOSTER CABLE When starting the engine with a booster cable, do as follows: Precautions When Connecting and Disconnecting Booster Cable A WARNING When starting the engine with a booster cable, always wear safety glasses. Be careful not to let the normal machine and problem machine contact each other. This prevents sparks from generating near the battery which could ignite the hydrogen gas given off by the battery. If hydrogen gas explodes. It could cause serious injury.

Make sure that there is no mistake in the booster cable connections. The final connection is to the engine block of the problem machine, but sparks will be generated when this is done, so connect to a place as far as possible from the battery. Use care when removing the cables from the machine that has been started. Do not allow the cable ends to contact each other or the machine, to avoid hydrogen explosion. 2-60