OPERATION 5. Operate bucket control lever and arm control lever slowly to move the bucket cylinder and arm cylinder to the end of their stroke. 6. Operate the bucket for 30 seconds and the arm for 30 seconds in turn fully for 5 minutes. REMARK Turn swing lock switch (3) ON (actuated) and operate the lever to make the oil temperature rise more quickly. NOTICE When the work equipment is retracted, take care that it does not interfere with the machine body or ground. 7. Turn fuel control dial (1) to the full speed (MAX) position and repeat the operation in Step 6 for 3 to 5 minutes. 8. Repeat the following operation 3 to 5 times and operate slowly.
Boom operation RAISE ш LOWER Arm operation IN ш OUT Bucket operation CURL ш DUMP Swing operation LEFT ш RIGHT Travel (Lo) operation FORWARD ш REVERSE REMARK If the above operation is not carried out, there may be a delay in response when starting or stopping each action, so continue the operation until it becomes normal. 9. Use working mode switch (2) on the monitor panel to select the working mode to be used. 2-61