Komatsu — 13.2.3 SECURING MACHINE

OPERATION 9. Raise the work equipment, pull in the arm under the boom, then move the machine slowly. 10. When the machine is horizontal on top of the rear wheels of the trailer, stop the machine. NOTICE If the machine is unloaded with the arm pulled in, the work equipment will be damaged. When moving on to the ramps, to prevent damage to the hydraulic cylinders, do not let the bucket hit the ground. 11. When moving from the rear of the trailer on to the ramps, set the angle of the arm and boom to 90 to 100 E , lower the bucket to the ground, then move the machine slowly. 12.

When moving down the ramps, operate the boom and arm slowly to lower the machine carefully until it is completely off the ramps. 13.2.3 SECURING MACHINE NOTICE Retract the radio antenna and remove the mirrors. Tie the removed parts securely to the trailer. To prevent damage to the bucket cylinder during transportation, fit a wooden block at one end the bucket cylinder to prevent it from touching the floor. After loading the machine on to a trailer, tie the machine down as follows. 1. When the machine becomes horizontal over the rear wheels of the trailer, stop the machine. 2. Swing the upper structure slowly 180 E , then move the machine slowly to the front of the trailer.

(If the machine is not equipped with work equipment, load it as it is.) 3. Stop the machine at the specified position on the trailer. 4. Extend the bucket and arm cylinders fully, then lower the boom slowly. 5. Stop the engine, then remove the key from the starting switch. 2-92