Komatsu — 15.2 DURING STORAGE WARNING

OPERATION 15. LONG TERM STORAGE 15.1 BEFORE STORAGE NOTICE To protect the cylinder rods when the machine is not being used, set the work equipment in the posture shown in the diagram. This prevents rusting of the cylinder rod. When putting the machine in storage for a long time, do as follows. ! After every part is washed and dried, the machine shall be housed in a dry building. Never leave it outdoors. In case it is required to leave it outdoors, park the machine on flat ground free from flooding or other danger and cover it with canvas etc. ! Completely fill the fuel tank, lubricate and change the oil before storage. !

Apply a thin coat of grease to metal surface of the hydraulic piston rods. ! Disconnect the negative terminals of the battery and cover it, or remove it from the machine and store it separately. ! If the ambient temperature is expected to drop below 0 E C, always add antifreeze to the coolant. ! Lock each control lever and pedal with the lock lever and pedal lock. ! Set the stop valve to the lock position on machines ready for attachments. Install the blind plugs to the elbows. ! Set the selector valve to the “When not use” position on ma- chines ready for attachments.

15.2 DURING STORAGE WARNING If it is unavoidably necessary to carry out the rust preventive operation While the machine is indoors, open the doors and windows to improve ventilation and prevent gas poisoning. Operate the engine and move the machine for a short distance once a month so that a new film of oil will be coated over movable parts and component surfaces. At the same time, also charge the battery. Also, operate the air conditioner in the case of machines equipped with an air conditioner. 2-99