OPERATION 16. TROUBLESHOOTING 16.1 PHENOMENA THAT ARE NOT FAILURES Note that the following phenomena are not failures: 1. When the arm is pulled in, the speed of movement will drop momentarily when the arm is more or less vertical. 2. The arm speed will drop momentarily when the bucket teeth are more or less horizontal. 3. When starting or stopping the swing, noise will be emitted from the brake valve. 4. When going down a steep slope at low speed, a noise will be emitted from the travel motor. 16.2 METHOD OF TOWING MACHINE WARNING When towing the machine, use a wire rope that has ample strength for the weight of the machine that is being towed.
If the machine sinks in mud and cannot get out under its own power, or if the drawbar pull of the excavator is being used to tow a heavy object, use a wire rope as shown in the diagram on the right. Place pieces of wood between wire ropes and body to prevent damage to ropes and body. Never use the light-weight hole for towing. 16.3 METHOD FOR LIGHT WEIGHT TOWING WARNING ! The shackle must always be used. ! Hold the rope level and direct it straight to the track frame. ! Move the machine slowly in the Lo mode. There is a hole in the track frame to fit the shackle when towing light objects. 16.4 PRECAUTION ON PARTICULAR JOB SITES 1.
When carrying out digging operations in water, if the work equipment mounting pins go into the water, carry out greasing every time the operation is carried out. 2. For heavy-duty operations and deep digging, carry out greasing of the work equipment mounting pins every time before opera- tion. After greasing, operate the boom, arm and bucket several times, then grease again. 2-101