Komatsu — 16.5.3 STARTING ENGINE WITH BOOSTER CABLE

OPERATION NOTICE The size of the booster cable and clip should be suitable for the battery size. The battery of the normal machine must be the same capacity as that of the engine to be started. Check the cables and clips for damage or corrosion. Make sure that the cables and clips are firmly connected. Connecting the Booster Cables Keep the starting switch at the OFF position. Connect the booster cable as follows, in the order of the numbers marked in the diagram. 1. Make sure that the starting switches of the normal machine and problem machine are both at the OFF position. 2. Connect one clip of booster cable (A) to the positive (+) terminal of the problem machine battery (1). 3.

Connect the other clip of booster cable (A) to the positive terminal of the normal machine battery (2). 4. Connect one clip of booster cable (B) to the negative (-) terminal (3) of the normal machine battery. 5. Connect the other clip of booster cable (B) to the revolving frame (4) of the problem machine. Starting the Engine 1. Make sure the clips are firmly connected to the battery terminals. 2. Start the engine of the normal machine and keep running at high idle speed. 3. Turn the starting switch of the problem machine to the START position and start the engine. If the engine doesn't start at first, try again after 2 minutes or so.

Disconnecting the Booster Cables After the engine has started, disconnect the booster cables in the reverse of the order in which they were connected. 1. Remove one clip of booster cable (B) from the revolving frame of the problem machine (1). 2. Remove the other clip of booster cable (B) from the negative terminal (2) of the normal machine. 3. Remove one clip of booster cable (A) from the positive terminal (3) of the normal machine. 4. Remove the other clip of booster cable (A) from the positive terminal (4) of the problem machine. 2-104