OPERATION 16.6.4 ELECTRONIC CONTROL SYSTEM If an error code is displayed on the machine monitor display (normally this displays the time), follow the self-diagnostic remedy table below. (@) For details of handling the pump control or swing lock override switches; See 11.2.12 PUMP CONTROL OVERRIDE SWITCH on page 2-18 or See 11.2.13 SWING LOCK OVERRIDE SWITCH on page 2-18.
2-108 Problem Main Causes Remedy Exhaust gas occasionally turns black • Clogged air cleaner element • Defective nozzle • Defective compression • Defective turbocharger • Clean or replace; See 24.2 WHEN REQUIRED on page 3-24 • (Replace nozzle) • See above • Clean or replace turbocharger Combustion noise occasionally makes breathing sounds • Defective nozzle • (Replace nozzle) Abnormal noise generated (com- bustion and mechanical) • Low grade fuel being used • Overheating • Damage inside muffler • Excessive valve clearance • Change to specified fuel • See above • (Replace muffler) • (Adjust valve clearance) Monitor display Failure Mode Remedy E02 TVC valve system error When the pump control override switch is turned ON, normal operations become normal, but carry out inspection immediately.
(@) E03 Swing brake system error Turn swing lock override switch ON and release brake. When applying swing brake, operate swing lock switch manually. In this case, carry out inspection immediately. (@) E05 Governor system error The governor cannot carry out control. Operate the governor lever manually. To secure at the full position, there is a mounting hole for the lock bolts in the bracket. In this case, carry out inspection immediately. CALL Operation cannot be continued Move machine to a safe posture, and carry out inspection immediately. If no error code is displayed but work equipment or swing cannot be operated Carry out inspection immediately.