MAINTENANCE 17. GUIDES TO MAINTENANCE Do not carry out any inspection or maintenance operation that is not given in this manual. Perform maintenance work on hard, flat ground. Check service meter: Check the service meter every day to see if the time has come for any necessary maintenance to be carried out. Komatsu genuine replacement parts: Use genuine Komatsu parts specified in the Parts Book as replacement parts. Komatsu genuine oils and grease: Use genuine Komatsu oils and grease. Choose oils and grease with the proper viscosities specified for ambient temperature. Also, keep containers of the oil and grease clean. Keep foreign materials away from oil and grease.
Always use clean washer fluid: Use automobile window washer fluid and be careful not to let any dirt get into it. Keeping the machine clean: Always keep the machine clean. This makes it easier to find parts causing problems. Keep in particular grease fittings, breathers and oil level gauges clean and avoid foreign matters from getting in them. Be careful of hot water and oil: Draining hot oils and coolants and removing their filters immediately after the engine stops are hazardous. Allow the engine to cool. If the oil has to be drained when it is cold, warm up the oil to a suitable temperature (approx. 20 to 40 E C(68 - 104 E F)) before draining it.
Checking foreign materials in drained oil and on filter: After oil is changed or filters are replaced, check the oil and filters for metallic particles and foreign materials. If large quantities of metallic particles or foreign materials are found, consult your distributor. Fuel strainer: Do not remove the fuel strainer while fueling. Oil change: Check or change oils in the places where dust is scarce to keep foreign materials away from oils. Warning tag: Attach the warning tag (09963-03000) to the starting switch or other appropriate control lever to avoid someone who is not aware of the circumstances from starting the engine.
During the operation, always obey the precautions on the safety label attached to the machine. Welding instructions: Turn off the engine starting switch. Do not apply more than 200 V continuously. Connect ground cable within 1 m from the area to be welded. Avoid seals or bearings from being between the area to be welded and the position of grounding point. Do not use the area around the work equipment pins or the hydraulic cylinders as the grounding point. Fire prevention: Use nonflammable cleaner or light oil for cleaning parts. Keep flame or cigarette light away from light oil. Clamp faces:
When o-rings or gaskets are removed, clean the clamp faces and replace the o-rings and gaskets with new ones. Be sure to fit o-rings and gaskets when assembling. 3-2