Komatsu — 24.2.2 CLEAN INSIDE OF COOLING SYSTEM

MAINTENANCE 24.2.2 CLEAN INSIDE OF COOLING SYSTEM WARNING ! Soon after the engine has been stopped, the coolant is hot and can cause personal injury. Allow the engine to cool before draining water. ! Since cleaning is performed while the engine is running, it is very dangerous to enter the rear side of the machine as the machine may suddenly start moving. If the under cover is left removed, it may interfere with the fan. While the engine is running, never enter the rear side of the machine. ! Never remove the radiator cap when the engine is at operating temperature. At operating temperature, the coolant is under pressure. Steam blowing up from the radiator could cause personal injury.

Allow the engine to cool until the radiator filler cap is cool enough to touch with your hand. Remove the filler cap slowly to allow pressure to be relieved. NOTICE: Never use water alone in the cooling system because corrosion will occur. In climates where the temperature is above -37 E C (-34 E F), use a coolant mixture that contains 50 percent antifreeze. Antifreeze is essential in any climate. It broadens the operating temperature range by lowering the coolant freezing point and by raising its boiling point. Do not use more than 50 percent antifreeze in the mixture unless additional freeze protection is required.

An antifreeze concentration greater than 68% will adversely affect freeze protection and heat transfer rates. Antifreeze concentrations between 68% and 100% actually have a higher freezing point than a 68% antifreeze concentration and should not be used due to reduced heat transfer rates. Low silicate ethylene or propylene glycol antifreeze is recommended. The antifreeze should contain no more than 0.1% anhydrous alkali metasilicate. Low silicate antifreeze is recommended to avoid the formation of silicate-gel (hydrogel). This gel formation can occur when the cooling system contains an over concentration of high silicate antifreeze and/or excessive supplemental coolant additive.

DO NOT use methanol or alcohol as an antifreeze because of its low boiling point. Super Coolant (AF-ACL) has an anti-corrosion effect as well as an antifreeze effect. The ratio of antifreeze to water depends on the ambient temperature, but to obtain the corrosion resistance effect, a minimum ratio of 30% by volume is necessary. NOTICE: Do not mix types of antifreeze solutions. Mixed solutions make it impossible to determine the protection against freezing. Antifreeze containing sealer or anti-leak additives should NOT be used in this system. Sealer or anti-leak additives will cause plugging problems in the cooling system.

Check the solution periodically and at normal operating temperature to be sure the cooling system has sufficient protection against freezing. ! When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing rate table given below. It is actually better to estimate a temperature about 10 E C lower when deciding the mixing rate. 3-27