Komatsu — 24.2.11 REPLACE ADD ON BREAKER FILTER ELEMENT

MAINTENANCE 24.2.11 REPLACE ADD ON BREAKER FILTER ELEMENT WARNING The oil is at high temperature after the engine has been operated, so never replace the filter immediately after finishing operations. Wait for the parts to cool down before changing the filter. ! Prepare a container to catch the oil. 1. Place a container under the filter element to catch the oil. 2. Turn filter case (1) to the left to remove, then take out element (2) and discard. Remove o-ring (4) from case and replace both with new. 3. Remove plug (3) from filter case (1). Discard o-ring (5) and replace with new. 4. Clean the removed parts. Replace plug (3) with new o-ring (5) to filter case.

Install new element (2) and o-ring (4) to case. 5. When installing, bring the case into contact with the filter holder, then tighten an additional Ѕ turn. NOTICE When the breaker is used, replace the element every 250 hours (when the breaker operating ratio is more than 50%) as shown in the table on the right. 3-41