Komatsu — 24.2.12 CLEAN IN LINE FILTER

MAINTENANCE 24.2.12 CLEAN IN LINE FILTER REMARK If the hydraulic system between the pump and in line filter (1) has been opened, or if there is any abnormality in the hydraulic equipment, remove the dirt inside the circuit as follows: 1. With a suitable container to catch oil, remove [one at a time] hose from filter to valve. 2. Remove filter (2) and discard o-ring (3) and back up ring (4). Clean filter as follows; a) When cleaning the filter, remove all dirt stuck to the side of the filter. b) When reassembling the filter replace o-ring (3) and back up ring (4) at the same time. c) Install filter and secure hoses. d) Start the engine and run at low idle for 5 minutes to bleed the air.

It is not necessary to operate the control levers to bleed the air. 3-42