MAINTENANCE 24.3 CHECK BEFORE STARTING 24.3.1 CHECK COOLANT LEVEL, ADD COOLANT WARNING Do not open the radiator cap unless necessary. When checking the coolant, always check the radiator reserve tank when the engine is cold. 1. Open the rear cover on the left side of the machine and check that the coolant level is between the FULL and LOW marks on radiator reserve tank (1) (shown in the diagram on the right). If the coolant level is low, add through the filler of reserve tank (1) to the FULL level. 2. After adding coolant, tighten the caps securely. 3. If the reserve tank becomes empty, first inspect for coolant leaks and then fill the radiator and the reserve tank.
For details of coolant; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9. 24.3.2 CHECK OIL LEVEL IN ENGINE OIL PAN WARNING The turbocharger (with safety cover) exhaust manifold is near dipstick (1), so be careful not to touch it. 1. Open the engine hood on the machine. 2. Remove dipstick and wipe the oil off with a cloth. 3. Insert dipstick fully in the oil filler pipe, then take it out again. 4. The oil level should be between the H and L marks on dipstick. If the oil level is below the L mark, add engine oil through oil filler. For details of the oil to use; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9 5.
If the oil is above the H mark, drain the excess engine oil from drain valve, and check the oil level again. 6. If the oil level is correct, tighten the oil filler cap securely and close the engine hood. REMARK When checking the oil level after engine has been operated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. 3-43