Komatsu — 24.3.4 CHECK OIL LEVEL IN HYDRAULIC TANK

MAINTENANCE 24.3.3 CHECK FUEL LEVEL WARNING When adding fuel, never let the fuel overflow. This may cause a fire. If you spill fuel, thoroughly clean up spillage. 1. Use sight gauge (G) on the front face of the fuel tank to check that the tank is full. 2. If the fuel level is not within the sight gauge, add fuel through filler port (F), while watching sight gauge (G). Fuel capacity: . . . . . . . . . . . . . . . . . . . . . . . . . 340 R (89.8 gal) For details of the fuel to use; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9 3. After adding fuel, tighten the cap securely.

REMARK If the breather holes (3) on the cap are clogged, the pressure in the tank will drop and the fuel will not flow. Clean the holes from time to time. 24.3.4 CHECK OIL LEVEL IN HYDRAULIC TANK WARNING ! When removing the oil filler cap, oil may spurt out, so turn the cap slowly to release the internal pressure before removing the cap. ! If oil has been added to above the H mark, stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from the drain plug. 1.

If the work equipment is not in the condition shown in the diagram on the right, start the engine, run the engine at low speed, retract the arm and bucket cylinders, then lower the boom, set the bucket teeth in contact with the ground, and stop the engine. 2. Within 15 seconds after stopping the engine, move each control lever (for work equipment and travel) to the full stroke in all directions to release the internal pressure. 3. Open the door on the right side of the machine. Check sight gauge (G). The oil level is normal if between H and L marks. NOTICE Do not add oil if the level is above the H line. This will damage the hydraulic equipment and cause the oil to spurt out. 4.

If the level is below the L mark, remove the upper cover of the hydraulic tank and add oil through oil filler (F). 3-44