Komatsu — 24.3.7 CHECK FUNCTION OF HORN

MAINTENANCE For details of the oil to use; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9 REMARK The oil level will vary depending upon the oil temperature. Accordingly, use the following as a guide: ! Before operation: around L level (Oil temperature 10 to 30 E C (50 to 86 E F)) ! Normal operation: around H level (Oil temperature 50 to 80 E C (122 to 176 E F)) 24.3.5 CHECK AIR CLEANER FOR CLOGGING 1. Confirm that the air cleaner clogging monitor does not flash. 2. If it flashes, immediately clean or replace the element.

For details of method of cleaning the element; See 24.2.1 CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT on page 3-24 24.3.6 CHECK ELECTRICAL WIRING WARNING ! If fuses are frequently blown or if there are traces of short circuit on the electrical wiring, locate the cause and carry out repair. ! Accumulation of flammable material (dead leaves, twigs, grass, etc.) around the battery may cause fire, so always check and remove such material. ! Keep the top surface of the battery clean and check the breather hole in the battery cap. If it is clogged with dirt or dust, wash the battery cap to clean the breather hole.

Check for damage and wrong capacity of the fuse and any sign of disconnection or short circuit in the electrical wiring. Check also for loose terminals and tighten any loose parts. Check the wiring of the battery, starting motor and alternator carefully in particular. When carrying out walk-around checks or checks before starting, always check if there is any accumulation of flammable material around the battery, and remove such flammable material. Please contact your distributor for investigation and correction of the cause. 24.3.7 CHECK FUNCTION OF HORN Turn the starting switch to the ON position. Confirm that the horn sounds without delay when the horn button is pressed.

If the horn does not sound, ask your distributor for repair. 3-45