MAINTENANCE 24.5 EVERY 250 HOURS SERVICE 24.5.1 CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING ! The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before starting the operation. ! If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare a handle. 1. Set the TOP mark at the top, with the UP mark and plug (1) perpendicular to the ground surface. 2. Remove plug (2) using the handle. When the oil level reaches a point 10 mm below the bottom of the plug hole, the correct amount of oil has been added. 3.
If the oil level is too low, install plug (2), operate the travel levers, and drive forward or in reverse to rotate the sprocket one turn. Then repeat Step 2 to check again. 4. If the oil level is still too low, add oil through the hole in plug (2) until the oil overflows. For details of the oil to use; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9 5. After checking, install plug (1). 24.5.2 CHECK LEVEL OF BATTERY ELECTROLYTE WARNING ! To avoid gas explosions, do not bring fire or sparks near the battery. ! Battery electrolyte is dangerous. if it gets in your eyes or on your skin, wash it off with large amounts of water, and consult a doctor.
Carry out this check before operating the machine. 1. Open the battery box cover on the right side of the machine. 2. Remove cap (1), and check that the electrolyte is at the specified level (10 to 12 mm (0.40 to 0.47 in) above the plate). If the level is low, add distilled water to the specified level. If the battery electrolyte is spilled, have dilute sulphuric acid added. 3. Clean the air hole in the battery cap, then tighten the cap securely. REMARK When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. 3-50