Komatsu — 24.6.1 REPLACE FUEL FILTER CARTRIDGE AND FUEL- WATER SEPARATOR

MAINTENANCE 24.6 EVERY 500 HOURS SERVICE Maintenance for every 100 and 250 hours service should be carried out at the same time. 24.6.1 REPLACE FUEL FILTER CARTRIDGE AND FUEL- WATER SEPARATOR WARNING ! Engine is at high temperature immediately after the machine has been operated. Wait for engine to cool down before replacing the filter. ! Do not bring fire or sparks near the fuel. Prepare a filter wrench and a container to catch the fuel. Fuel catch container . . . . . . . . Min 3.8 R (1 gal) capacity Filter wrench . . . . . . . . . . . . . . . . . . . . . . . . 09019-08035 1. Set the container to catch the fuel under the cartridges. 2. Using a filter wrench, remove cartridges (1) and (2).

3. Clean the cartridge holder. 4. Fill a new cartridge with clean fuel, coat the packing surface with engine oil, then install it to the cartridge holder. 5. When installing, tighten until the packing surface contacts the seal surface of the cartridge holder, then tighten it up Ѕ to ѕ of a turn. If the cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. After replacing the fuel cartridges, bleed the air from the system as follows: 3-55