MAINTENANCE 24.6.3 CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS AND CONDENSER FINS (ONLY FOR MACHINES EQUIPPED WITH AIR CONDITIONING) WARNING If compressed air, steam, or water hit your body directly, there is danger of injury. Always wear protective glasses, mask, and safety shoes. 1. Open the engine hood and rear door on the left side of the machine. Loosen bolts (1) and remove the radiator front cover. 2. When cleaning radiator fins, remove four bolts (2) fixing the oil cooler to the radiator. Tilt the oil cooler outward, then clean the radiator fins. 3.
Blow off mud, dust or leaves clogging the radiator fins, oil cooler fins and after cooler fins using compressed air. At the same time, clean the net in front of the oil cooler. Clean the condenser fins on machines equipped with air conditioner. Steam or water may be used instead of compressed air. After cleaning, secure the oil cooler with bolts (2) and install the cover with bolts (1). REMARK An aftercooler is installed on the PC270LC-6. 4. Check the rubber hose. Replace with a new one if the hose is found to have cracks or to be hardened by ageing. Further, check hose clamps for looseness. NOTICE To prevent damage to the fins, apply compressed air from and appropriate distance.
Damaged fins may cause water leakage or overheating. In a dusty site, check the fins daily, irrespective of the maintenance interval. 3-58