MAINTENANCE 24.6.6 CHANGE ENGINE OIL, REPLACE FILTER WARNING The oil is at high temperature after the machine has been operated. Always wait for the temperature to go down before starting this operation. Prepare the following. Oil catch container . . . . . . . . . . Min 26.3 R (7 gal)capacity Filter wrench . . . . . . . . . . . . . . . . . . . . . . . . 09019-08035 Refill capacity . . . . . . . . . . . . . . . . . . . . . . . . . 24 R (6.3 gal) 1. Place a container under drain valve (P) located on the bottom of the machine. 2. Loosen drain valve (P) slowly to prevent getting oil on yourself, and drain the oil. 3.
Check the drained oil, and if there are excessive metal particles or foreign material, please contact your distributor. 4. Close drain valve (P). 5. Open the engine hood. Using the filter wrench from the upper side of the engine, turn filter cartridge counterclockwise to remove it. In particular, if this operation is carried out immediately after stopping the engine, a large amount of oil will come out, so wait for 10 minutes before starting the operation. 6. Clean the filter holder, coat the packing surface of a new filter cartridge wiht engine oil (or coat it thinly with grease).
REMARK Confirm that no remnants of old packing still adhere to the filter holder as this may result in oil leakage. REMARK Do not over tighten filter or use any tools for installation because this can damage the gasket and filter. 7. Fill the new filter with clean oil. 8. Install the new filter. 3-60