Komatsu — 24.7.1 CHANGE OIL IN SWING MACHINERY CASE

MAINTENANCE 24.7 EVERY 1000 HOURS SERVICE Maintenance for every 100, 250 and 500 hours service should be carried out at the same time. 24.7.1 CHANGE OIL IN SWING MACHINERY CASE WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before carrying out maintenance. Oil catch container . . . . . . . . . . . . 5.5 R (1.5 gal) minimum Refill capacity . . . . . . . . . . . . . . . . . . . . . . . . 5.5 R (1.5 gal) 1. Set a container under drain valve (P) under the machine body to catch the oil. 2. Loosen drain valve (P) under the machine body, drain the oil, then tighten the drain plug again. 3.

Remove dipstick (G) and air bleed plug (1), then add the specified amount of oil through gauge hole (F). For details of the oil to use; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9. 4. After adding oil, install air bleed plug (1). 5. Wipe off the oil on the dipstick with a cloth. Insert dipstick (G) fully into the guide, and then pull it out again. 6. The oil level should be between top H and bottom L marks on the dipstick (G). If the oil does not reach the bottom mark, add engine oil through gauge hole(F). If the oil is above the top mark, drain the excess engine oil from drain valve (P), and check the oil level again. 3-63