Komatsu — 24.8.1 CHANGE OIL IN FINAL DRIVE CASE

MAINTENANCE 24.8 EVERY 2000 HOURS SERVICE Maintenance for every 100, 250, 500 and 1000 hours service should be carried out at the same time. 24.8.1 CHANGE OIL IN FINAL DRIVE CASE WARNING ! The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before carrying out maintenance. ! If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare the following. Oil catch container . . . . . . . . . . . . 10 R (2.6 gal) minimum Refill capacity . . . . . . . . . . . . . . . . . . . . . . . . 9.5 R (2.5 gal) 1.

Set the TOP mark at the top, with the TOP mark and plug (1) perpendicular to the ground surface. 2. Set a container under plug (1) to catch the oil. 3. Remove plugs (1 and 2) and drain the oil. REMARK Check the o-rings on plugs for damage. If necessary, replace with new ones. 4. Screw in plug (1). 5. Add oil through the hole of plug (2). For details of the oil to use; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO TEMPERATURE on page 3-9. 6. When the oil overflows from the hole of plug (2), install plug (2). Tightening torque of plugs Both plugs . . . . . . . . . . . . . . . 70 ±10 N C m (50.7 ±1 lbf ft) 3-66