Komatsu — 24.8.6 CHANGE ANTIFREEZE

MAINTENANCE 24.8.2 CLEAN HYDRAULIC TANK STRAINER The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before changing the oil. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it carefully. 1. Remove 4 bolts, then remove cover (1). When doing this, cover may fly off because of the force of spring (2). So keep the cover pushed down when removing the bolts. 2. Hold the top of rod (3) and pull up to remove spring (2) and strainer (4). 3. Remove any dirt stuck to strainer (4), then wash. If strainer is broken, replace it with a new part. 4.

When installing, insert strainer (4) into protruding part (5) of the tank, and assemble. 5. Tighten the bolts to install cover (1). 24.8.3 CLEAN, CHECK TURBOCHARGER Contact your distributor for cleaning or inspection. 24.8.4 CHECK ALTERNATOR, STARTING MOTOR The brush may be worn, or the bearing may have run out of grease, so contact your distributor for inspection or repair. If the engine is started frequently, carry out inspection every 1000 hours. 24.8.5 CHECK VIBRATION DAMPER Check that there are no cracks or peeling in the outside surface of the rubber. If any cracks or peeling are found, contact your distributor.

24.8.6 CHANGE ANTIFREEZE Follow the procedure of 24.2.2 CLEAN INSIDE OF COOLING SYSTEM on page 3-27 for draining and refilling the cooling system. 3-67