Komatsu — 24.8.7 CHECK AND ADJUST VALVE CLEARANCE

MAINTENANCE 24.8.7 CHECK AND ADJUST VALVE CLEARANCE Adjusting the valves 1 .Remove the valve covers. 2. Locate top dead center (TDC) for cylinder Number 1 by turning engine slowly while pressing on the engine timing pin (A). 3. When the pin engages the hole in the crankshaft gear, Cylinder Number 1 is at TDC on the compression stroke. CAUTION: Be sure to disengage the pin after locating TDC. Valve clearance: Intake: 0.254 mm (0.010 in) Exhaust: 0.508 mm (0.020 in) Check/set valves with engine cold - below 60 E C (140 E F). NOTE: The clearance is correct when some resistance is "felt" when the feeler gauge is slipped between the valve stem and the rocker lever.

With the engine in TDC position, check and adjust the following valve clearances: Intake (I) cylinders: 1,2,4 Exhaust (E) cylinders: 1,3,5 Tighten the locknut to 24 N C m (18 lbf ft) and recheck the valve lash. Mark the pulley and rotate the crankshaft 360 Degrees. Be sure the timing pin is disengaged before rotating. The timing pin will not engage in this position. With the engine in this position, check and adjust the following valve clearances. Intake (I) cylinders: 3, 5, 6 Exhaust (E) cylinders: 2, 4, 6 3-68