Komatsu — 24.10.1 CHANGE OIL IN HYDRAULIC TANK

MAINTENANCE 24.10 EVERY 5000 HOURS SERVICE Maintenance for every 100, 250, 500 and 1000 hours service should be carried out at the same time. 24.10.1 CHANGE OIL IN HYDRAULIC TANK WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before changing the oil. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it carefully. Prepare the following. Oil catch container . . . . . . . . . Min 166 R (44 gal) capacity Ratchet wrench . . . . . . 24 mm socket and/or Ѕ in. Drive Refill capacity . . . . . . . . . . . . . . . . . . . . . . . . 166 R (44 gal) 1.

Swing the upper structure so the drain plug at the bottom of the hydraulic tank is in the middle between the left and right tracks. 2. Retract the arm and bucket cylinders to the end of the stroke, lower the boom, and put the teeth in contact with the ground. 3. Set the safety lock lever to the LOCK position and stop the engine. 4. Remove the cap of oil filler port (F) at the top of the hydraulic tank. 5. Set a container immediately under the drain plug under the machine body to catch the oil that is drained. Using the handle, remove drain plug (P) and drain the oil. Take care not to get oil on yourself when you remove drain plug.

Check the o-ring installed to plug (F), and if it is scratched or damaged, replace the o-ring. After draining the oil, tighten the drain plug. Tightening torque: Drain plug . . . . . . . . . . . . . . . . . 69 ±10 N C m (50 ±7 lbf ft) 6. Add the specified amount of engine oil through oil filler port (F). Check that the oil level is between H and L on the sight gauge. For details of the oil to use; See 20 FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE on page 3-9 3-71