Komatsu — 24.10.1 CHANGE OIL IN HYDRAULIC TANK

MAINTENANCE c.) Use the work equipment to jack up the chassis so that the track comes slightly off the ground, then run the track under no load for 2 minutes. Carry out this operation on the left and right sides. When rotating the track under no load, rotate the track uniformly in forward and reverse. 6. Bleeding air from attachment (hydraulic breaker, etc.) - If a hydraulic breaker or any other attachment has been newly installed, run the engine at low idle and operate the equipment repeatedly (~ 10 times) until the air has been bled from the attachment and circuit.

NOTICE If the method of bleeding the air from the attachment itself is specified by the manufacturer, bleed the air according to those specifications. 7. Operation a) After completing the air bleed operation, stop the engine and wait for at least 5 minutes before starting operations. This will allow the bubbles in the oil inside the tank to escape. b) Check that there is no leakage of oil, and wipe up any oil that has been spilled. 3-74