Komatsu — 24.10.1 CHANGE OIL IN HYDRAULIC TANK

MAINTENANCE 2. Start the engine. For details: See 12.2 STARTING ENGINE on page 2-54. Run the engine for 10 minutes at low idle, then go on to the next operation. 3. Bleeding air from cylinders a.) Run the engine at low idle, and extend and retract each cylinder 4 to 5 times. Do not operate the cylinder to the end of its stroke. Stop at a point ~ 100 mm (4 in.) before the end of the, stroke. b.) Next, operate each cylinder 3 to 4 times to the end of its stroke. c.) Finally, operate each cylinder 4 to 5 times to the end of its stroke to completely remove the air.

NOTICE If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder may cause damage to the piston packing. 4. Bleeding air from swing motor - Carry out this operation only when the oil in the swing motor case has been drained. a.) Run the engine at low idle, loosen air bleed plug (1) and check that oil oozes out from air bleed plug. NOTICE When doing this, do not operate the swing. b.) If no oil oozes out, stop the engine, remove air bleed plug then fill the motor case with hydraulic oil. c.) After completing the air bleed operation, tighten air bleed plug (1).

d.) Run the engine at low idle, and swing the upper structure at least 2 times uniformly to the left and right. NOTICE If the air is not bled from the swing motor, the motor bearings may be damaged. 5. Bleeding air from travel motor - Carry out this operation only when the oil in the travel motor case has been drained. a.) Run the engine at low idle, loosen air bleed plug (1) and check that oil flows out. If oil flows out, tighten the air bleed plug. Stop the engine and refill the motor case with oil. b.) With the engine running at low idle, and swing the upper structure 90 E to bring the work equipment to the side of the track. 3-73