Komatsu — 30.1.5 ADDITIONAL FILTER FOR BREAKER

OPTIONS, ATTACHMENTS 30.1.2 SELECTOR VALVE This switches the flow of the hydraulic oil. For details of the attachment to install and the direction of the lwft and right 3-way valves (1) and (2), See 30.2 HYDRAULIC CIRCUIT on page 5-11. This pedal is used to operate the attachment. The pedal can be depressed to the front, neutral, and rear to operate the attachment as follows. 30.1.3 CONTROL PEDAL Hydraulic breaker Front of pedal (1) . . . . . . . . . . . . . . . . . . . . . . . . . . Actuate Pedal neutral (N) . . . . . . . . . . . . . . . . . . . . . . . . . . . . Stop Rear of pedal (2) . . . . . . . . . . . . . . . . . . . . . . .

Locked out For use of the pedals with other attachments, consult with the attachment manufacturer at the time of installation to determine the operation of the attachment and pedals. 30.1.4 LOCK PIN This locks the control pedal. Position (1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Lock Position (2) . . . . . . . . . . . . . . . . . . . . . . . Pedal forward stroke Position (3) . . . . . . . . . . . . . . . . . . . . . . . . . . . Pedal full stroke ! When using the breaker, select the breaker mode on the monitor, and use position (3). ! If another attachment is used at lower flow, select position (2).

Keep the lock pin in the LOCK position (1) except when using the attachment. 30.1.5 ADDITIONAL FILTER FOR BREAKER This is used to prevent deterioration of the hydraulic oil when using the breaker. The oil flows through this only when the selector valve is at the breaker position. See 30.2 HYDRAULIC CIRCUIT on page 5-11. 5-10