Komatsu — 30.3.2 PROCEDURE FOR INSTALLATION

OPTIONS, ATTACHMENTS INSTALLATION OF ATTACHMENT 30.3.1 PROCEDURE FOR REMOVAL 1. Lower the attachment to the ground and stop the engine. 2. After stopping the engine, operate each control lever and attachment control pedal to the front and rear, and left and right 2 or 3 times to the end of its stroke to release the remaining pressure inside the hydraulic circuit. 3. After checking that the oil temperature is low, turn the rotor of the stop valve connected to the inlet and outlet piping on the arm side face toward the lock side. 4. Remove the hoses from the attachment line, then install blind covers to the inlet port and outlet port (2 places).

The blind covers are to prevent defective actuation of the attachment caused by the entry of dirt or dust, so fit them securely before storing the parts away. 5. Pull out the mounting pins (2 places), remove the attachment, then install the bucket. For details of the procedure for installing the bucket; See 12.16 REPLACEMENT OR INVERSION OF BUCKET on page 2-83. 6. After installing the bucket, check the oil level in the hydraulic tank. 30.3.2 PROCEDURE FOR INSTALLATION 1. Remove the bucket. For details of the procedure for removing the bucket; See 12.16 REPLACEMENT OR INVERSION OF BUCKET on page 2-83. 2.

Place the attachment in a horizontal position, then install to the arm with pin (1) and then pin (2). 3. After installing the attachment, stop the engine. Then operate each control lever and attachment control pedal to the front and rear, and left and right 2 or 3 times to the end of its stroke to release the remaining pressure inside the hydraulic circuit. 4. After checking that the oil temperature is low, remove the tube caps from the outlet port (2 places) tubes. Be careful that no dirt or mud is stuck to the attachment hose mouthpiece. 5-13