SAFETY WARNING: For reasons of safety, always follow these safety precautions. ! Spilled oil or grease, or scattered tools or broken pieces are dangerous because they may cause you to slip or trip. ! Always keep your machine clean and tidy. ! If water gets into the electrical system, there is danger that the machine may not move or may move unexpectedly. ! Do not use water or steam to clean the sensors, connectors, or the inside of the operator's compartment. When carrying out welding repairs, carry out the welding in a properly equipped place. The welding should be performed by a qualified worker.
During welding operations, there is the danger of generation of gas, fire, or electric shock, so never let an unqualified worker do welding. The qualified welder must do as follows. ! To prevent explosion of the battery, remove the battery terminals. ! To prevent generation of gas, remove the paint from the location of the weld. ! If hydraulic equipment or piping or places close to them are heated, a flammable gas or mist will be generated and there is danger of it catching fire. To avoid this, never subject these places to heat. ! If heat is applied directly to rubber hoses or piping under pressure, they may suddenly break, so cover them with a fireproof covering. !
Wear protective clothing. ! Make sure there is good ventilation. ! Remove all flammable objects and provide a fire extinguisher. ! When repairing the electrical system or when carrying out electrical welding, remove the negative (-) terminal of the battery to stop the flow of current. ! If any abnormality is found during inspection, always carry out repairs. In particular, if the machine is used when there are still problems with the brake or work equipment systems, it may lead to serious injury. ! If necessary depending on the type of failure, please contact your distributor for repairs.
1-30 KEEP THE MACHINE CLEAN WELDING REPAIRS REMOVE BATTERY TERMINALS ACTION WHEN ABNORMALITY IS FOUND DURING INSPECTION