Komatsu — 8.2 DURING MAINTENANCE

SAFETY WARNING: For reasons of safety, always follow these safety precautions. ! When inspecting or replacing high pressure piping or hoses, check that the pressure has been released from the circuit. Failure to release the pressure may lead to serious injury. Always do as follows. ! For details of the method of releasing the pressure: ! See 8.1 STOP THE ENGINE BEFORE CARRYING OUT INSPECTION AND MAINTENANCE on page 1-26 Do not carry out any inspection or replacement operation before the pressure has been completely removed. !

If there is any leakage from the piping or hoses, the piping and hoses and the area around them will be wet, so check for cracks in the piping or cracks or swelling in the hoses. If it is difficult to find the location, please contact your distributor. ! Wear protective glasses and leather gloves. ! If oil is leaking under high pressure from small holes, it is dangerous if it hits your skin or enters your eyes. It may make holes in your skin or cause blindness. If you are hit by a jet of high-pressure oil and suffer serious injury to your skin or eyes, wash off the oil with large amounts of water, then consult a doctor immediately for medical attention. !

Immediately after stopping machine operations, the engine cooling water and oil at all parts are at high temperatures and under high pressure. In this condition, if the radiator cap is removed, or the oil or water are drained, or the filters are replaced, this may result in burns or other injury. Wait for the temperature to go down, then carry out the inspection and maintenance in accordance with the procedures given in this manual. Cleaning inside of cooling system ! See 24.2.2 COOLING SYSTEM on page 3-27 Checking cooling water level, hydraulic oil level ! See 24.3 CHECK BEFORE STARTING on page 3-43 Checking lubricating oil level, adding oil !

See 24.3 CHECK BEFORE STARTING on page 3-43 Changing oil, replacing filters ! See 24.3 CHECK BEFORE STARTING on page 3-43 To prevent pollution of the environment, always do as follows. Never dump waste oil in a sewer system, rivers, etc. Always put oil drained from your machine in containers. Never drain oil directly onto the ground. Obey appropriate laws and regulations when disposing of harmful materials such as oil, fuel, solvent, filters, and batteries. 1-32 PRECAUTIONS WITH HIGH PRESSURE OIL PRECAUTIONS WHEN CARRYING OUT MAINTENANCE AT HIGH TEMPERATURE OR PRESSURE WASTE MATERIALS