OPERATION 2. Power Maximum, Swift Slow Down Switch During operations, the knob switch can be operated at a touch to increase the power or reduce the speed (while the switch remains pressed). When power maximum light illuminates: When the working mode is set to H/O or G/O mode, the power is increased while the knob switch is kept pressed. Even if the knob switch is kept pressed, the power maximum function is stopped after approximately 8.5 seconds. When swift slow down light illuminates: When the working mode is set to H/O or G/O mode, the speed is reduced while the knob switch is kept pressed. When the engine is started, the power max light illuminates.
Each time the SET switch is pressed, the mode is switched. 3. Travel Speed Switch WARNING If the Hi-Lo switch is operated when the machine is traveling, the machine may deviate even when traveling in a straight line. To prevent this, always stop the machine before operating the travel speed switch. This is used to select the three travel speeds. Lo light illuminates - Low speed travel. Mi light illuminates - Middle speed travel Hi light illuminates - High speed travel. When the engine is started, the travel speed is automatically set to Lo.
When traveling in high speed travel (Hi) or middle speed travel (Mi), the travel speed is automatically switched to low speed travel (Lo) to match the travel surface on soft ground or when traveling uphill, so there is no need to operate this switch. Monitor light remains illuminated (Hi or Mi). 4. Auto-deceleration Switch This switch acts to activate the function that automatically lowers the engine speed and reduces fuel consumption when the control lever is at neutral. ON lights up : Auto-deceleration is actuated. OFF : Auto-deceleration is canceled. 2-13