OPERATION 11.3.2 TRAVEL LEVERS WARNING ! Do not put your foot on the pedal unless the machine is traveling. If you leave your foot on the pedal and press it by mistake, the machine will move suddenly, and this may lead to a serious accident. ! With the track frame facing to the rear, the machine will move in the reverse direction by forward traveling and in the forward direction by reverse traveling. When the travel lever is used, check to see if the track frame is facing forward or backward. (If the sprocket is located to the rear, the track frame is facing forward.) 1. FORWARD: The lever is pushed forward, the pedal is angled forward 2. REVERSE:
The lever is pulled rearward, the pedal is angled back 3. NEUTRAL: The machine stops REMARK When the lever(s) or foot pedal(s) is/are shifted to the reverse position, the alarm sounds to warn that the machine is starting to move. 11.3.3 LEFT WORK EQUIPMENT CONTROL LEVER WARNING If any lever is operated when in the deceleration range, the engine speed will suddenly increase, so be careful when operating the lever. This lever is used to operate the arm and upper structure. When the lever is in the NEUTRAL (1) position, the upper structure and the arm will be retained in the position in which they stop.
For lever position 2, 3, 4 and 5, the engine speed changes as follows because of the auto-deceleration mechanism. ! When the travel levers and work equipment control levers are at neutral, even if the fuel control dial is above the midrange position, the engine speed will drop to a midrange speed. If any of the levers are operated, the engine speed will rise to the speed set by the fuel control dial. ! If all control levers are set to neutral, the engine speed will drop by approx. 100 rpm, and after approx. 4 seconds, the engine speed will drop to the deceleration speed, approx. 1400 rpm.
2-20 1 NEUTRAL Swing Operation Arm Operation Swing Operation 2 ARM OUT 4 SWING TO RIGHT 3 ARM IN 5 SWING TO LEFT