OPERATION 11.3.4 RIGHT WORK EQUIPMENT CONTROL LEVER WARNING If any lever is operated when in the deceleration range, the engine speed will suddenly increase, so be careful when operating the lever. This lever is used to operate the arm and upper structure. 1 Bucket Operation 2 BUCKET DUMP 3 BUCKET CURL When the lever is in the NEUTRAL (1) position, the boom and the bucket will be retained in the position in which they stop. For lever position 2, 3, 4 and 5, the engine speed changes as follows because of the auto-deceleration mechanism. !
When the travel levers and work equipment control levers are at neutral, even if the fuel control dial is above the midrange position, the engine speed will drop to a midrange speed. If any of the levers are operated, the engine speed will rise to the speed set by the fuel control dial. ! If all control levers are set to neutral, the engine speed will drop by approx. 100 rpm, and after approx. 4 seconds, the engine speed will drop to the deceleration speed, approx. 1400 rpm. ATTACHMENT CONTROLS 2-21 NEUTRAL Boom Operation BOOM RAISE 4 BOOM LOWER 5