OPERATION 11.3.5 ATTACHMENT CONTROL PEDAL WARNING Do not put your foot on the pedal except when operating it. If you rest your foot on the pedal during operations, and you depress the pedal by mistake, the attachment may move suddenly and cause serious damage or injury. When breaker is installed ! When the front of the pedal is depressed, the breaker is actuated. ! The positions of the lock pin are as follows: lock (1), pedal half stroke position (2), pedal full stroke position (3). ! Set the working mode to the breaker mode and set the lock pin to position 2. When general attachment is installed ! When the front of the pedal is depressed, the attachment is actuated.
The positions of the lock pin are as follows: lock (4), pedal half stroke position (5), pedal full stroke position, (6). Path of hydraulic oil When the front of the pedal is depressed, the oil flows to the left piping for the work equipment; or when the rear of the pedal is depressed, the oil flows to the right piping for the work equipment. (When the breaker is installed, only the front of the pedal is used.) 11.3.6 SELECTOR VALVES FOR BREAKER AND GENERAL ATTACHMENT (crusher etc.) WARNING Do not touch the relief valve. When a breaker or general attachment (such as a crusher) are used, turn the rotors of the 3-way valves в and г to change them over according to the following illustration.
(The arrow marks indicating the port direction are stamped on the 3- way valve heads.) 2-22