Komatsu — 11.4.1 FASTEN THE BELT AND REMOVE IT

OPERATION NOTICE Stop the engine and lower the work equipment and chassis to the ground to set in a stable position before carrying out the operation. REMARK For details, See 30 MACHINES READY FOR ATTACHMENTS on page 5-9. 11.4 SEAT BELT WARNING ! Before fastening the seat belt, inspect the securing brackets and belt for abnormal conditions. Replace any worn or damaged seat belt or the securing brackets. ! Adjust and fasten the seat belt before operating the machine. ! Always use seat belt when operating the machine. ! Do not use seat belt with either half of the belt kinked. 11.4.1 FASTEN THE BELT AND REMOVE IT 1.

Adjust the seat so that there is sufficient knee room when fully depressing the pedals while seated, with the operators back against the backrest. 2. For suspension type seat, adjust tether belt (1), after adjusting the seat position. 3. After adjusting the seat position, sit in the seat. Grip buckle (2) and tongue (3) in each hand and insert tongue into buckle. Confirm by pulling the belt that the tongue is securely locked to the buckle. 4. When removing the belt, raise the tip of buckle (2) lever to release it. 2-23 Attachments Left valve (1) Right valve (2) Breaker Forward direction of machine Machine Left 7L Right Crusher etc.

Forward direction of machine Machine Left 7L Right When not in use Forward direction of machine Machine Left 7L Right