OPERATION Fasten belt along your body without kinking it. Adjust the lengths of the belt on both the buckle and the tongue sides so that the buckle is located at the midpoint of your body front. 11.4.2 ADJUST THE BELT LENGTH To shorten the belt Pull the free end of the belt on either the buckle body or tongue side. To lengthen the belt Pull the belt while holding it at a right angle to buckle or tongue. Inspect bolts and fittings on the chassis for tightness. Tighten any loose bolts to 20 to 29 N C m (15 to 20 lbf ft) torque. If the seat belt is torn or frayed or if any of the fittings are broken or deformed from long service, replace the seat belt immediately. 11.5 ROOF VENT WARNING !
When leaving the operators compartment, set the safety lock lever securely to the LOCK position. ! If the control levers are not locked, and they are touched by mistake, this may lead to a serious accident. When opening 1. Lock the safety lock lever securely. 2. Open the two lock knobs (2) located on the left and right side, then push up and open the roof vent grasping grip (1) until gas springs (each side) are fully extended. When closing 1. Close the roof vent by grasping grip (1) to overcome gas springs. Secure roof vent to cab with lock knobs (2). If the locks cannot be applied, reopen and close the roof vent again. 2-24